Mobilsol PM (engl.)

Mobilsol PM

Mobilsol PM Seite 1 von 3 Mobilsol PM Synthetic Based Cleaner for Lubrication Systems Product Description Mobilsol PM is a highly detergent and dispersant synthetic fluid which, when added to the oil in hydraulic, paper machine or general circulation systems, will help to release and hold in suspension gummy oil oxidation products and insoluble materials. Efficient clean up of the system from deposits accumulated with time in reservoirs and pipework can therefore be achieved leading to the recovery of the system original operating efficiency and to improved equipment protection. Features and Benefits Mobilsol PM offers the following benefits: Features Higher flash point than light viscosity petroleum based solvents Free from corrosive materials Limited effect on seals even at high operating temperatures High level of detergency High level of dispersancy Advantages and Potential Benefits Can be added to systems without shutting down Downtime is limited to the drainage and refilling operations Needs no special precautions for storage or use Cleans fouled systems by promoting the removal of foreign deposits, carbonaceous material and sludge Holds contamination in suspension to assist removal in filters Clean up of circulation systems contributes in improving operating efficiency and prolonging equipment life Applications Mobilsol PM should be used in accordance with the following instructions or recommendation should be sought from Mobil technical service: Introduce Mobilsol PM into a contaminated system progressively in 1% increments based on the total volume of system, (maximum to be used 4%). Circulate dirty lubricant / Mobilsol PM mixture for 3-10 working days whilst regularly checking the condition of all filters. Additional filtration equipment may be required when proper operation of the system could be affected by the release of high amounts of deposits. Oil condition monitoring can be of assistance to monitor the level of deposits being picked up in the oil. Drain the system whilst hot and flush with a small volume (10% of the system volume or less) of the new product being introduced. Replace all filters and cartridges etc. and fill up with the new circulation oil. Where pump or bearing manufacturers specify a maximum viscosity for a particular operation, the change in viscosity caused by the addition of Mobilsol PM should be calculated from blending tables. In some cases it may be necessary to blend Mobilsol PM with a lower viscosity oil before adding it to the fluid in use. Note: Do not use Mobilsol PM in N C machine tools or servo valve systems without special engineering consideration. In any systems incorporating sensitive servo control valves even very small particles of dirt introduced with the solvent/fluid mixture or dislodged by it may interfere with the valve operation. Cleaning hydraulic systems incorporating servo valves must be carried out strictly in accordance with the manufacturers' instructions. http://pds.mobil.com/Germany-English/Lubes/PDS/EUXXENINDMOMobilsolPM.as... 15.04.2016